Ero sivun ”Valmistelevat toimenpiteet” versioiden välillä
(→Axis calibration) |
|||
Rivi 25: | Rivi 25: | ||
==Axis calibration== | ==Axis calibration== | ||
− | * Check [[Ohjauspaneeli| Control Panel LEDs]] that none of the motion axes X, Y, Z are already at or very close to the home boundary. If necessary, move the shaft manually away from the home limit before driving home. This is because the machine easily travels against the end limit switch if it is already very close to the home station when driving home. | + | * Check [[Ohjauspaneeli| '''Control Panel LEDs''']] that none of the motion axes X, Y, Z are already at or very close to the home boundary. If necessary, move the shaft manually away from the home limit before driving home. This is because the machine easily travels against the end limit switch if it is already very close to the home station when driving home. |
* Start home run on all axles: | * Start home run on all axles: | ||
:: * select [HOME] from the control panel | :: * select [HOME] from the control panel |
Versio 12. huhtikuuta 2021 kello 23.28
Sisällysluettelo
Valmistelevat toimenpiteetEnnen kuin koneella aletaan työstämään ja erityisesti ennen MDI- tai automaattiajoa, on kaikki akselit kalibroitava. Muussa tapauksessa koordinaatit ovat mitä sattuu eikä mikään onnistu. Akselien kalibrointi
Akselit on nyt kalibroitu ja asematieto säilyy kaikissa tilanteissa kunnes koneesta taas otetaan sähköt pois. |
Preparatory actionsAll axes must be calibrated before working on the machine, especially before the MDI or automatic run. Otherwise, the coordinates are what happens and nothing works. Axis calibration
The shafts have now been calibrated and the position information is retained in all situations until the power is removed from the machine again. |