Optinen kaiverrin

General Information

The optical engraver is connected to a Raspberry PI 3 Model B with Raspbian Jessie running version 3.256.0 of LaserWeb3.

• multicast address: laserweb.local
• IPv4: 192.168.110.176 (not guaranteed to be the same)
• LaserWeb is listening on port 8000

Steps to engrave/cut an SVG:

Preparig the Machine

1. Make sure the power is turned on both in the extension cord and in the machine itself
2. Install the workpiece and close the lid
3. Turn the laser on (green button, check that the red led turns on)
4. Turn on the lights (flip the small metallic switch)
5. Check that the laser power is set at an appropriate level

Engraving the SVG

1. Browse to http://192.168.110.176:8000 or http://laserweb.local:8000
2. Click the Open button and select an SVG image or drag-and-drop it
3. Configure the feedrate, number of passes and depth of each pass
4. Click the Generate G-Code button
5. Click the Process button to load the G-Code
6. Click the run gcode (Play) button to run the G-Code
7. After the machine is idle, click the home laser button to return the laser home

Installing the Workpiece

• If possible, use the clamps. The laser focus seems to be good at the depth of the clamp.
• The maximum height of an object that fits the clamp is roughly 80mm.
• If engraving larger pieces, make sure that they stay still and don't move. A few drops of superglue should hold them still.

Observations on Cutting Depths

Feedrate	Laser Power	Passes	Cut depth observations
20mm	5mW	10	Barely a scratch, might work for engravings
20mm	10mW	5	About the same as 5mW x 10
20mm	15mW	5	Roughly half a millimeter
20mm	20mW	5	Roughly half a millimeter
20mm	20mW	30	Around 2-3mm, acrylic started to melt
40mm	20mW	30	Around 2-3mm, clean cut

Debugging

If the engraver doesn't seem to be connected to LaserWeb, try reconnecting the USB cable to the engraver and then reload the web page.